Proceed as follows:
- Align all the magnetic plates in the same direction.
Example:
All magnetic plates must be attached in such a way that the positioning holes point to the right upper corner. - Fasten the magnetic plate to the machine bed. The minimum screw-in depth should be 6.5 mm. The tightening torque is 2.5 to 3.5 Nm.
- The other magnetic plates can now be assembled in a same way.
| Proceed as follows:
- Remove all protective plates.
- Check that the carriage can move smoothly and without hindrance over the magnetic plates.
- The alignment of the magnetic plates should be checked if there are significant variations in the force when moving from one magnetic plate to the next.
|
