Mounting

►Carefully degrease the following components with a cloth:

Contact surfaces with adjacent components
Centering and motor shaft
Internal diameter of the clamping hub
Spacer sleeve inside and outside

In case of motor with feather key [+]

►Remove feather key [+] and insert half wedge

►Remove the plug [1] from the adapter plate [2]

►Turn the clamping hub [1] until the screw [2] can be seen above the mounting hole

►Loosen the screw [2] by one turn

Do not exceed the permissible axial forces

If the motor shaft cannot be inserted easily, the screw on the clamping hub must be loosened a little more.

With certain motor shaft diameters, a slotted spacer sleeve must be installed in addition. If there is a groove on the motor shaft, it must be aligned with the slot in the spacer sleeve.

►Insert the motor shaft [1] into the clamping hub [2]

►Make sure that no gap is created between the motor and the adapter plate

This example shows a motor size with four fixing points in the flange.

►Coat screws [1], [2], [3] and [4] with threadlocker

►Insert bolts [1], [2], [3] and [4] and tighten evenly

►Tighten bolt [5]. Refer to the chapter Clamping hub.

►Insert the plug in the adapter plate again