Old probing signal parameters (up to CNC Build V2.11.2019.14)

To supply the probing signals, one of the following measurement methods can be defined.

a signal of a probe is read in via the hardware interface of the NC kernel (conventional method),
the SERCOS interface outputs a message when the probe signal arrives,
a bit of the axis-specific control bit mask of the position controller is set,
a probe signal is read in via a special HLI control unit,
an internal probing signal is generated if the specified position lag limit is exceeded (fixed stop)..

Notice
If a measurement method is selected, all other measurement methods must be deselected!