Wiring with push-in connection technology EC/ED/EFxxxx
| |
Risk of electric shock and damage of device! Bring the bus terminal system into a safe, powered down state before starting installation, disassembly or wiring of the bus terminals! |
Fig.18: Wiring and disconnecting the conductors- 1. Connect solid conductors and conductors with ferrules (Fig. top left, step 2)
These can be connected using the direct plug-in technique without tools.
- Insert the conductor into the terminal point after stripping the insulation (2)
- 2. Connect fine-stranded cables (Fig. top right, steps 1 - 3)
These must be connected via the push-button.
- Use a screwdriver to press the push-button to open the contact point (1).
- Then insert the conductor (2).
- Release the push-button by pulling back the screwdriver to close the terminal point (3).
Release cables (Fig. above steps 4 - 6)
The release is carried out for all conductor types using the push-button.
- Use a screwdriver to press the push-button to unlock the contact (4).
- Then pull out the conductor (5).
- Release the push-button by pulling back the screwdriver to close the terminal point (6).
Notice | ||
 | Observe the permissible connection cross-sections and strip lengths The permissible conductor cross-section and strip length depend on the type of housing, please refer to the housing data in the "Technical data" chapter for the device in question. | |