Infosys在阅读器中打开 / AI 翻译

TS8xxx - Building Automation · 0 次阅读

EnOcean Digital Signal

EnOcean Digital Signal analyses the telegram of a digital EnOcean transmitter.

Settings

EnOcean Digital Signal 1:

Parameters

  • On Delay: Time delay on.
  • Off Delay: Time delay off.
  • Long / Double Click: Time to recognize both long- and double-click, which are used to activate scenes, see below. If the button is pressed longer than this time, it is interpreted as a long-click. Pressing the button twice within this time span will be recognised as a double-click.
  • Negate Digital Input: Negates the digital input.
EnOcean Digital Signal 2:

Subsystem Assignment

  • Transmitter Id: Id of the EnOcean-transmitter.
  • Id of the KL6583 (only for 6581): Id of the terminal.
  • Watchdog: EnOcean-modules sending frequent telegrams, like presence-sensors, can be observed with this function. For switch-modules, however, a watchdog does not make sense and must be deactivated by entering 0s.
  • Module Type: The correct transmitter type, as described in the manual / manufacturer-reference, must be selected here.
  • Data Byte / Data Bit: The proper Data byte / Data Bit of the desired value have to be entered.

Pressing the Linked to...-button opens a dialog, where the designated EnOcean-line can be assigned to this module.

Counter

EnOcean Digital Signal 3:

Parameters

  • Multiplier: Multiplier for the counter.
  • Offset: Offset to add to the counter.
  • Unit: The unit of the scaled value. For display-purposes in the Building Automation Framework only.
  • Direction: Counting direction.

Scenes

EnOcean Digital Signal 4:

Pressing the New-button within the Scenes-menu opens a dialog, where the analysed events

  • Rising edge
  • Falling edge
  • Edge changed
  • Click
  • Double click
  • Long click

(See logical diagram above) can be assigned to the execution of a scene. The scene however must be defined previously.

Online

EnOcean Digital Signal 5:

State

  • Value: Resulting value, see logical diagram above.
  • Raw Value: Raw value received from the digital input terminal including activated / deactivated negation (see logical diagram above).
  • Counter: Current value of the counter.
  • Set Counter Direct: Value to set direct to the counter.

State PLC Module

  • Execution State: Shows, if the module is running or stopped.
  • Error: In case of an error, the error code and the error parameter are displayed in this box.
  • Start/Stop: Starts/stops the module.